Wtb driveshaft see specs

[69gt4speed]

I need a driveshaft.

Basically 47" u joint center to u joint center would be ideal. 3" dia all the way. Slip yoke, one piece. Longer would be ok also, can get it cut down. A 1330 u joint cap is 1.125 dia, 3.625 length. I just didn't want to cut down my original 50". For my 69 bb btw. I have both a 28 and 31 splined slip yoke. Old tranny is 30" new is 33".

[CiViC-Wanted]

i would call fast shaft in Des Moines.

[boxmakingman]

Sadler in CR took care of my odd ball shaft right quick.

Awesome service, fair price, quality job.

More then willing to work with people on custom 'race car' shafts

[SLVR7]

Agreed,Sadler is the place to go.

[DustinsDuster]

they did my driveshaft as well. i took in an old junk one, and they cleaned it, shortened it, balanced, painted it and replaced the U-joints for around $120 if i remember right. still going strong too...

[69gt4speed]

Yes Sadler is perfectly fine. I just thought maybe someone had another ds they could cut and balance. You never know what ppl have laying around in the garage. I guess I'll have mine cut and balanced.

[black88gt]

if a fox driveshaft is longer, i could set you up w/ one to cut for your needs

[69gt4speed]

I measured my existing shaft at 50" from center of u joint to center of u joint, (the main shaft) I need 47" (perfect) or more. A 5.0 has that adapter flange for the diff. and 28 spline slip yoke. No biggy. Mine is 3" dia steel all the way fron u to u. I looked at a pickup one piece f100 but that was 3.5" dia don't know if that would clear tunnel. Btw 3" is approx. 9.5" circumferance by a tape measure. 3x3.14