PDA

View Full Version : TAB, maybe something for you fellas to do


Drifte
10-05-2008, 04:49 PM
Have my fuel pump assembly out and stripped down. Need to have the feed tube cut out and replaced. Ive seen people weld some stuff, use some rubber hose and clamps and so on. I'll share the pics and you can give me your opinion, all it needs is drilled out replaced, just a lot of different ways to go about it.

As for the pics:
Drifte
10-05-2008, 04:50 PM
Something like this...

http://www.dsmtuners.com/forums/attachments/newbie-forum/62107d1143413164-photo-fitting-fuel-line-1.jpg

http://www.corvid-corax.net/images/talon/pump3.jpg

http://i68.photobucket.com/albums/i17/paulvolk/100_1339.jpg

http://i68.photobucket.com/albums/i17/paulvolk/100_1345.jpg
Drifte
10-05-2008, 04:51 PM
I'll ship it out tomorrow if your down to ride
96-eclipse-gst
10-05-2008, 05:41 PM
Yea go ahead and ship it out. You want to put an AN fitting on or what? I'll pm you Trev's address so you can ship it to him, that should be cheapest.
TbTalon94
10-05-2008, 09:41 PM
Lemme know which you'd like to do Colton. A barbed fitting, pushlock, or AN fitting. I can probably find one laying around or grab one from Sperry or something. Won't take long to weld on.
Drifte
10-06-2008, 09:54 AM
Yea i didnt think it'd take much for you guys, I have no resources around here to do a damn thing. I'll ship it out tomorrow asap. Idk what would be best for it. But if after you guys weld it up, you could grind all the shit off and paint/prime it or something that'd be super!

All I know I need is that fitting to mate up like stock to the fuel line.

oh, stro is going to be headed your way tuesday, so Im sending the unit with him.
Drifte
10-14-2008, 12:31 PM
And we have it here basically done. No ghetto rubber hose clamped in between either, welded straight up to the in-tank feed line. I want to cut, solder and heat shrink those crimp connectors but Im afraid the heat shrink tubing will be eaten by the gas.
TbTalon94
10-14-2008, 04:27 PM
Your welcome :)
Drifte
10-14-2008, 04:45 PM
yes thank you, now I need to know if I can heat shrink the wires!
JustinS
10-15-2008, 11:50 AM
Looks like damn fine work you guys did there. Hats off to you.
CiViC-Wanted
10-15-2008, 02:28 PM
Thats looks awsome!!I'd like to have the AN fitting welded on my valve cover for the catch can. Just out of curoisuty how much would or did something like this cost, and maybe to AN fittings on a valve cover.
TbTalon94
10-16-2008, 09:15 AM
You have a PM