PDA

View Full Version : AEM ems, 1g/2g dsm performance/stock/ricer parts



Sean485
05-07-2008, 08:32 PM
Alright I'm looking into getting a 2g spyder project car (pm me if you have or know of one near Iowa...) so I'm selling off some parts that wont transfer over or wont need. Also just clearing out some parts from the garage that have been collecting dust. All prices are OBO and w/o shipping.

$1300 aem ems; had about 1,500 miles on it when it got sent off to aem after car died out of nowhere. They re-loaded everything and said its good to go. Car started and ran fine but never really drove it after I got it back.

$350 4 bolt LSD rear diff

$400 5spd 1g AWD tranny, PERFECT condition, never any grinds.

$125 93+ big brakes, some surface rust but work great

$200 Fluidyne aluminum radiator, some bent fins where the intake pipe/filter came loose but no leaks at all

$90 1g jay racing alternator relocation kit, not powdercoated like the new ones are

$50 1g poly mounts, already in the factory mounts

$400 extreme psi 28" Length X 10.5" Height X 3.62" Diameter fmic 2.5 in/out w/ rear facing in/outlets

$300 ground control coilovers 1g AWD

$50-all 3 1gb talon tinted taillights

$300 kyb agx shocks/struts 1g AWD, good shape

$250 kyb agx shocks/struts 2g AWD, adjusters missing on front struts, can be purchased directly from kyb for cheap.

$125- 1ga talon/1ga/b eclipse chrome altezza taillights. Perfect shape.

$30 1g 3 gauge pillar pod

$20 1g 3 gauge center vent pod

$20 Stock 2g intake manifold

$30 Stock 1g intake manifold

$35 stock 1990 or 1991+ 1g NT throttle bodies

$30 A/C compressor 1g or 2g

$40/set 1g "big" rods, several sets available

$125 each turbo XS rfl or type H bov's

$50 2g mas w/ plug

$100 23 spline t-case

$40/each rust free 1ga fenders

$300 Good shape 92 2.0 NT tranny

$150 90 2.0 NT tranny, did shift perfect but got left outside over the winter so current condition unknown.

$150 91 5spd awd tranny, bad synchros. All the gears worked, just had to shift it slow.

**Best offer for any of the following parts**

water pump or timing belt related pulleys

Dont really want to ship these but I have 3 fiberglass z3 fenders for a 1gb, 2 are in good shape and in gel coat(one passenger, one driver), Also have another passenger that is damaged at the bumper mount and painted red. Make an offer.

1gb eclipse gsx spoiler

1g door/hatch/mirror parts

Stock 1g or 2g smic

Stock 2g cylinder head

Stock 97 7 bolt shortblock, ran fine, didn't burn anything. Pulled out of gf's car to put in built 6 bolt.

91 awd trans, tore it apart for the center diff, had bad synchros so any parts you may need let me know. Bell housing, etc in good shape.

Shifter bases, shift cables pedal boxes, clutch/brake master cylinders, non-abs brake lines, stock flywheel/clutches for turbo and NT.

If there is anything else you need or want pics of something specific just pm me and I will get them for you asap.

Thanks for looking, Sean.

TbTalon94
05-08-2008, 08:46 AM
I have 2g dsmlink if you want that for your new up-comming project :)

Sean485
05-08-2008, 09:16 PM
I have 2g dsmlink if you want that for your new up-comming project :)
Sorry, I think i'm going to stick with the AEM unit, just need one for a 2g, dont feel like modifying a 1g unit to work.

Sean485
05-09-2008, 01:18 AM
More stuff to add to the list. I just "aquired" a fairly clean 1990 gsx 5spd; the tranny is shady but it has a few mods that are up for sale and most of the stock parts will be up for grabs as well.

hard upper and lower IC pipes for 1g bov, 14b/16g turbo
2g exhaust manifold (small crack, then was welded)
in line MBC, unsure of brand
2 gauge a pillar pod
autometer 30-0-30 boost gauge
reverse indiglo gauges
3 bolt LSD rear end
cf hood for a 1gb dsm; rough shape but still lightweight.
etc, etc

Make offers guys, I know somebody needs some parts and I really want my convertable Wink

Stutz
05-09-2008, 11:50 PM
How much for the 90 gsx? pics?

StreetSweeper
05-10-2008, 01:55 AM
How many miles on the tranny, and what spline is it.

Sean485
05-10-2008, 06:46 AM
How much for the 90 gsx? pics?
Im not selling the car running, the tranny in it is JUNK and it has some title issues. If your looking for a shell I will be selling both my blue talon and the gsx as a shell when everything else is gone.

Street Sweeper - the car has ~200k miles, whether its the original trans I dont know but I never had any problems with it letting me in at 8,200 rpm. Its a 92 trans, 23 spline.

CiViC-Wanted
05-13-2008, 09:58 PM
Do the 2g struts have springs on them, if so are they stock or lowering springs.

CiViC-Wanted
05-13-2008, 10:00 PM
Dont worry about the struts now, i have FWD not a AWD sorry!

Sean485
05-14-2008, 04:06 PM
They should fit your fwd

CiViC-Wanted
05-14-2008, 10:05 PM
If i remeber right the front fit but the rears are differnet

Sean485
05-14-2008, 10:32 PM
For 1gs but 2gs they springs are stiffer for the extra awd weight but the struts are the same.

94TSI
05-15-2008, 08:41 PM
is the 2g head nt or turbo? if its nt what condition is it in? bolt on a drive or need work? also how much you want for it?

Sean485
05-15-2008, 10:38 PM
It is a turbo head. 1g nt and turbo heads are the same. 2g nt heads are for the 420a chystler engine. 2g turbo heads will work on 1gs but the ports are smaller so they are ussually ported out before they are swapped onto 1gs.

I have a few heads but only really looking to get rid of the one from my gfs car. It didn't smoke or anything. Just pulled it to swap in a built 6 bolt.

Sean485
05-25-2008, 09:32 PM
I'm taking offers on the kyb agx struts w/ ground control coilovers, I would really like to sell these locally. I also still have the cf hood, 2 good 1g awd trannys, transfer cases, 4 bolt LSD rear ect. I sold some of the stuff on ebay but this stuff is all too heavy to ship.

Make some offers guys, I bought my spyder and none of this stuff will fit so I just want it out of the garage.

Drifte
05-26-2008, 01:39 PM
if I didnt have to have my money for a deposit on a new place I would take:

cf hood, pedal assembly, tranny and x-fer case. but untill I know how much goes into deposit I cant make any purchases. sorry

Sean485
05-29-2008, 07:08 PM
Nobody else? This is all high end stuff. No ebay knockoff crap.

I'm also selling the shell of my 92 talon no rust on the body, just some surface rust on the undercarriage. I will sell the chassi (has a cage tack welded in with sfi approved 5pt harnesses and sumped stock fuel tank). With the kyb agx struts/ground control coilovers good tranny a good 6 bolt block and crank good head transfer case and varous other parts you would need to get it going for 1200.

If you need something else post here or pm me. I need the garage space.

Luminatorz34
05-29-2008, 07:52 PM
if i ever get this car ive been trying to get for the past 2months (kid ignoring my calls when told i could pick up this week) if i get it, ill hit u up for parts...i dont want to call dibs on anything just incase this deal falls thru (again)

Drifte
05-29-2008, 08:24 PM
you have a complete 6bolt you will sell?

Sean485
05-29-2008, 08:55 PM
I have a perfect 6 block with a spotless crank that I will throw in with the sale of the my shell and I have a complete turbo longblock that looks to have been rebuilt very recenly but I'm not really looking to sell either outright. If I was made the right offer I would sell them I suppose.

I do have a few 6 bolt blocks without cranks that need bored if you looking for something along those lines.

Sean485
06-01-2008, 01:00 PM
Still trying to sell this stuff, really want to get rid of the 4 bolt, kyb agx struts w/ ground control coilovers, and the shell of the car. NONE of this stuff will fit my 2g and I need it gone. The shell will be going to the crusher this weekend if I dont get any buyers... Somebody has to want an awd dsm for cheap...

DustinsDuster
06-01-2008, 01:01 PM
Steve is looking for one; i believe he wants a running/driving car though....

Luminatorz34
06-01-2008, 01:23 PM
already got ahold of him dustin..thanks though

CiViC-Wanted
06-09-2008, 12:03 AM
Hey do you still have the 7 bolt short block if so how much.

belittle
06-09-2008, 09:54 AM
Hey do you still have the 7 bolt short block if so how much.

Hey I have a complete 7 bolt motor also :) can't count me out.

Sean485
06-09-2008, 10:12 AM
Yea, I have it. 400 for the shortblock, no crank play. Ran great when removed to drop in a built 6 bolt.

oVa-Boost
07-04-2008, 05:06 PM
got any 6 bolt motors for sale

Sean485
07-05-2008, 02:05 PM
got any 6 bolt motors for sale
I have a complete, stock 6 bolt longblock freshly rebuilt. I will likely be using that temporarily in my spyder (until I build a better flowing head for my built g4cs) unless I get a good offer for it, I also have a 6 bolt block/crank that are in mint condition and several 6 bolt blocks that need bored w/o cranks.