Domestic Disturbance
07-24-2013, 02:43 AM
Parting out my 2000 Camaro SS. Navy Blue metallic, 6 speed, black interior. Car is still together right now but I'm just trying to gauge interest. Pm me if there's anything of interest you'd want off of it. I'm keeping the engine/harness.
Full t56 swap includes -
~75k mile tremec t56 6 speed transmission
10k mile ls7 clutch
10k mile ls2 flywheel
Tick Performance Adjustable Master Cylinder
GM slave replaced with clutch job
Tick Performance remote bleeder
UMI Transmission Crossmember (black) with torque arm relocation
MGW short throw shifter
Stock black leather Hurst Knob
Black center console
$2300
Interior is black leather. Not sure yet but drivers side door panel looks like it still might be good.
SLP Black Camaro SS Floor Mats - $100
UMI Drag Sway Bar (black) Needs new bushings/clamps that mount it to the big clamps on the axle tubes - $250
Custom true dual exhaust made by H&W. 3 inch, mandrel bent, aluminized steel. 2 borla xr1 tubes mounted to 1 side. Some small dents on turndowns, mufflers are dented/scraped up but sound good still - $450
SLP Lid - $75
K&N Filter (less than 5k on it) - $30
Pacesetter Longtubes No EGR - $250
OEM SLP SS Hood (a few light scratches on it) - $500
OEM SLP SS Spoiler (not sure if its good yet) - $250
4 275/40r17 tires. Unknown brand. Less than 2k miles. $300
SLP Ram Air scoop - $75
Good passenger door, front fender, passenger door window.
SLP Smooth Bellow - $30
Not sure about Moser 12 bolt rear end yet. Not sure if its salvagable, parting it out, etc yet.
Anything else just ask
Would take $4k without engine/harness :biglaugh:
Full t56 swap includes -
~75k mile tremec t56 6 speed transmission
10k mile ls7 clutch
10k mile ls2 flywheel
Tick Performance Adjustable Master Cylinder
GM slave replaced with clutch job
Tick Performance remote bleeder
UMI Transmission Crossmember (black) with torque arm relocation
MGW short throw shifter
Stock black leather Hurst Knob
Black center console
$2300
Interior is black leather. Not sure yet but drivers side door panel looks like it still might be good.
SLP Black Camaro SS Floor Mats - $100
UMI Drag Sway Bar (black) Needs new bushings/clamps that mount it to the big clamps on the axle tubes - $250
Custom true dual exhaust made by H&W. 3 inch, mandrel bent, aluminized steel. 2 borla xr1 tubes mounted to 1 side. Some small dents on turndowns, mufflers are dented/scraped up but sound good still - $450
SLP Lid - $75
K&N Filter (less than 5k on it) - $30
Pacesetter Longtubes No EGR - $250
OEM SLP SS Hood (a few light scratches on it) - $500
OEM SLP SS Spoiler (not sure if its good yet) - $250
4 275/40r17 tires. Unknown brand. Less than 2k miles. $300
SLP Ram Air scoop - $75
Good passenger door, front fender, passenger door window.
SLP Smooth Bellow - $30
Not sure about Moser 12 bolt rear end yet. Not sure if its salvagable, parting it out, etc yet.
Anything else just ask
Would take $4k without engine/harness :biglaugh: