Fiero Roll Bar $250 OBO

[Fiero]

Bar is made out of .120 x 1.5" DOM tubing. The floor and firewall plates are 3/16" thick. Bar is slightly crooked, but it's hard to tell unless you lay it flat on the floor. Will probably interfere with some seat travel, but I haven't installed it yet so I am not sure. If you instal this, you will want to weld a metal plate over your passenger side drain plug as one of the bolts will go there. I know this will fit without a car interior (B Piller trim, Carpet, Headliner, Glove box, ect..) But I have not had it in a car with a full interior. It may fit some other cars, I'm not sure. But if you are interested I can provide you with measurements. When I made this bar I did my best to try to conform to the SCCA guidelines, But I have not taken it to a tech inspection yet. Comes with large washers and grade 8 bolts and nuts. Bar has been painted red. Similar bars sell for $400 or $500. I will consider trades for a motorcycle or early 80's late 70's moped. Let me know what you have. 250 OBO
http://i1213.photobucket.com/albums/cc468/2m4/IMAG0336.jpg
http://i1213.photobucket.com/albums/cc468/2m4/IMAG0337.jpg
http://i1213.photobucket.com/albums/cc468/2m4/IMAG0334.jpg
http://i1213.photobucket.com/albums/cc468/2m4/IMAG0327.jpg