T-70 Turbonetics Journal Bearing

[Batwood]

I wasn't really planning on selling this, but I figured if somebody wanted it, I could get a T76 or ball bearing T70 or something.

I don't know any of the exact specs, other than its a T-70 with T4 flange.
No "up and down" shaft play. Just a little side-to-side, but nothing bad.
It was on a ZZP twincharged car that went 9.9@144 apparently.

Make offer if interested...

[Fire Hawk]

You have an idea of what your looking to get out of it? I'd be interested if the price is right.

[sLoWnStEaDy]

^same^


Also, any way you could get measurements? or a part number or something? I am going to do a blow-thru turbo setup on the RX5.0 this winter and could always get a jump start on buying parts...

[Batwood]

I asked the guy I got it from about the A/R or any other specifics.
It says HP29391 or something like that on the back of the cold side.
All I know for sure is its a T70 with T4 flange.
I would hope for something around $850... I made a downpayment on a twincharged kit I'm getting... so it basically cost me $1,000.

Let me know if you guys are really interested or something... It would be nice to have some extra cash. PM an offer or something...

[Batwood]

I think $850 might have been too much...
Make offer?