Scott
01-07-2010, 02:35 PM
Wonder what the dyno sheet looks like on this beast
http://i248.photobucket.com/albums/gg178/427fogger/blown2jz.jpg
Found off another website so not sure how accurate this is.
"Lots of custom fab went into this and so far the motor is making 1700 hp on the engine dyno at 28 psi but power comes on almost instantly. Custom billet crank made by Bryant and so the snout is holding up fine. We are worried about too much mid range torque we already windowed a previous block on carillos. The current motor has aluminum rods. This is going in a sand rail btw"
http://i248.photobucket.com/albums/gg178/427fogger/blown2jz.jpg
Found off another website so not sure how accurate this is.
"Lots of custom fab went into this and so far the motor is making 1700 hp on the engine dyno at 28 psi but power comes on almost instantly. Custom billet crank made by Bryant and so the snout is holding up fine. We are worried about too much mid range torque we already windowed a previous block on carillos. The current motor has aluminum rods. This is going in a sand rail btw"