Alternator bracket...?

[sLoWnStEaDy]

Wondering how much tohave this made out of 1/2" 6061-T6 aluminum and polished to match the rest of my March brackets? I want to lower the alternaot in the RX7 quite a bit in the engine bay so I have to make something up...

This is the actual size of the bracket (roughly 8"x4.5", I held my cardboard cut-out up to the screen and traced it). I will obviously have to get you the measurements on the holes if you do it but I figured that would be enough for an estimated cost. Obviously wanting the edges rounded, and everything the same width etc... this was just a quite paint up I did so...

http://img9.imageshack.us/img9/9716/loweraltbracket.png (http://img9.imageshack.us/i/loweraltbracket.png/)


here are the other brackets I have which I am trying to make this one kind of "blend in" with. I can bring the other alt bracket (as pictured below) in so you can see it and use it as some what of a "template" as far as the width of the cross of the "bars" and how far to counter sink the holes etc...
http://img21.imageshack.us/img21/4251/c4f01sbl.jpg (http://img21.imageshack.us/i/c4f01sbl.jpg/)
http://img17.imageshack.us/img17/2153/mustangpowersteeringbra.gif (http://img17.imageshack.us/i/mustangpowersteeringbra.gif/)

[TbTalon94]

I'll check on some prices for the aluminum and get back to you tomarrow Keith. That will definatly not be a problem if I have all thr measurements.

[sLoWnStEaDy]

Sweet... I still have a good hookup from when I was a fabricator at All State Steel so I can get the material pretty cheap if not free depending on your cost... I know I can get 1/2" thick by 6"x12" for <$20 since I've purchased it once before when I was working on the Bronco...

forgot to mention the holes will be like 5/16" and the counter sinks are 7/16" IIRC... Thanks for the speedy response! If things go well (and I am sure they will) I have some other stuff I will need done since I have limited access to the A.S.S. shop now.

[TbTalon94]

You've got a PM