PDA

View Full Version : Hennessey modded zr1 goes 11.03 @ 136



69gt4speed
01-28-2009, 12:30 AM
For the chevy/vette ppl the 700 kit zr1 at they say cold track, one thing it's got the mph.
Not esp fond of hennessy though. Vette guy sent it to me...
http://videos.streetfire.net/video/2009 ... 547883.htm (http://videos.streetfire.net/video/2009-Corvette-ZR1-ZR700_547883.htm)

Domestic Disturbance
01-28-2009, 01:20 AM
Ya hennessy isn't really getting much out of that car. Its like a $5000 upgrade too, and they picked up like 20-30rwhp. Theres others that have picked up double that for less than half. I'd love to see a zr1 with a driver that wasn't garbage

DustinsDuster
01-28-2009, 05:04 PM
not too terribly impressive- werent there guys running similar times in stock Z06's?

slow ride
01-28-2009, 05:14 PM
Guys will run mid 10's in these bone stock in good air out east come spring time. C5z's have gone mid/high 11's and C6z's low 11's high 10's all stock. Not quite so fast around here due to higher density altitude most of the time.

allgo
01-28-2009, 05:29 PM
give it time and plenty of them will be in the 10s stock, I dont care if it didnt go 10s I would rock one of those any day of the week... badassss.

69gt4speed
01-29-2009, 12:56 PM
Well like said 136 tells me 10's soon. Hopefully someone run like a 10.6 to put rangers old record to rest.

snickerlicker
01-29-2009, 03:06 PM
A couple runs were in the 137 and 138 mph range. Thats low 10's hooked up no problem..

Drifte
01-29-2009, 03:10 PM
what exactly is the upgrade? A supercharger?

FiFdYnUtZ
01-29-2009, 04:26 PM
well beings it already has the new style eaton blower on it im sure there isnt a replacement version out yet. I would bet the kit consists of very minor intake/exhaust/pulley/tune mods...

Domestic Disturbance
01-29-2009, 10:29 PM
hennessy probably put a bigger pulley on...

Drifte
01-29-2009, 11:09 PM
Ok had to go look up the new vette to see just what it was. The z06 has a 7.0l 500hp and the zr1 a 638hp 6.2l I think I would just go with a zo6. Unless their is a lot more to it? ls3 on z06 and ls9 on zr1, them bottom lone vette comes with a 6.2l version of the ls3. Besides all the bells and whissles a zo6 seems like the best option. "mo replacement for displacement" ... Right? Basically thinking out loud here but up per dollar I'd go z06 with bolt ons, hell a super chargers a bolt on!

69gt4speed
01-29-2009, 11:40 PM
2009 Corvette ZR1 - Hennessey ZR700: 11.03 @ 136 mph:

ZR700 - 705 HP Engine Upgrade:

- Power: 705 HP @ 6,400 rpm
- 717 lb-ft Torque @ 3,800 rpm

Performance:
- 0-60 mph: 3.1 sec.
- 0-150 mph: 13.9 sec. (stock = 17.1 sec.)
- 1/4 mile: 11.0 @ 136 mph (tested on factory Michelin tires)
- Top Speed: 212 mph (estimated)

Inlcudes:
- Supercharger Pulley & Blower Snout Upgrade (increases boost from 11 to 14 psi)
- Intercooler System Upgrade
- K&N Air Filter
- Re-program Engine Management Computer
- Stainless Steel 1 7/8 inch Headers
- High Flow Catalytic Converters with Mid Pipes
- Hennessey & ZR700 Exterior Emblems (Optional)
- Hennessey ZR700 Premium Floor Mats
- Professional Installation at HPE
- Dyno Testing & Tuning

69gt4speed
01-30-2009, 12:15 AM
Btw at 14 psi that's almost double the n/a c.i. minus efficiency losses. The reason they did a 6.2l version for this is cylinder liners are thicker to take the boost/airflow/combustion heat and pressures, however u like to think. It is forcing in almost 2x the n/a airflow minus efficiency loss.

Drifte
01-30-2009, 08:34 AM
^ Gotcha, I was wondering if the 7.0L was the same block but really bored out..or atleast something like that. Now I need to calculate my little 2.0l's displacement at 25psi.

Domestic Disturbance
01-30-2009, 12:33 PM
Ok had to go look up the new vette to see just what it was. The z06 has a 7.0l 500hp and the zr1 a 638hp 6.2l I think I would just go with a zo6. Unless their is a lot more to it? ls3 on z06 and ls9 on zr1, them bottom lone vette comes with a 6.2l version of the ls3. Besides all the bells and whissles a zo6 seems like the best option. "mo replacement for displacement" ... Right? Basically thinking out loud here but up per dollar I'd go z06 with bolt ons, hell a super chargers a bolt on!

LS7 on Z06, LS3 is 08+ C6 vette :goodman: . And yes, they went to a 6.2L in terms of durability. The LS7 is still a small block, so it has a few weaker points compared to the 6.2L which has thicker cylinder wall gaps. It is more than just a few bells and whistles though. Read some comparisons on the ZR1 vs Z06, and you'll be surprised and how much more tame, yet capable, they made it. Sorry to ramble but I do love ZR1s. They make GTRs looks like a computer put on a bigwheel :biggrin: